Skip to content
+32 (0) 9 340 44 04 info@eco2box.com

TL;DR For raspberry micropropagation and blackberry, size the vessel on the floor: 20 shoots get 3.2 cm2 each in an Eco2Box OV80 and 4.0 cm2 each in an O118/80. For rooting, measure shoot height first: the O118/120 and O118/140 add height. Start multiplication on filter grade XXL and compare it with XXL+ on your own clones. No published vessel trial on raspberry or blackberry was found, so this page gives a method and a test plan, not a result.

Labs planning raspberry micropropagation often ask for the right pot and filter for about 20 plants per vessel, and whether rooting needs a larger pot. No published study answers that for raspberry or blackberry: a search of open literature found work on media and rooting, and nothing on vessels. This page applies the floor-area method to both crops, says what is known, and marks what you have to test yourself.

Which container suits raspberry and blackberry in vitro?

For about 20 shoots per vessel in multiplication, compare the oval Eco2Box OV80 (64 cm2 floor, 80 mm high) with the round O118/80 (79 cm2 floor, 80 mm high). For rooting, compare the O118/120 or the O118/140, which add height on a 64 cm2 floor. These are starting points from published sizes, not trial results.

Stage What limits the choice Articles to compare Grade to start with
Multiplication, about 20 shoots Floor area per shoot OV80 and O118/80 XXL, next to XXL+
Rooting in vitro Height of the shoots O118/120 and O118/140 No guidance published: test side by side
Last weeks before transfer Gas exchange The size you root in XXL+ where it exists for the article

Multiplication: which vessel takes 20 raspberry shoots?

At 20 shoots per vessel, the Eco2Box O118/80 gives each shoot 4.0 cm2 of floor, the O118/50 gives 3.6 cm2 and the OV80 gives 3.2 cm2. The O118/80 has 23% more floor than the OV80 at nearly the same volume. Which of these is enough depends on how wide your clusters are on the last day of the cycle.

Article Height Base area (calculated) Floor per shoot at 15 shoots At 20 shoots At 25 shoots
O95/60 60 mm 50 cm2 3.3 cm2 2.5 cm2 2.0 cm2
OV80 80 mm 64 cm2 4.3 cm2 3.2 cm2 2.6 cm2
O118/50 50 mm 71 cm2 4.7 cm2 3.6 cm2 2.8 cm2
O118/80 80 mm 79 cm2 5.3 cm2 4.0 cm2 3.2 cm2
O118/120 120 mm 64 cm2 4.3 cm2 3.2 cm2 2.6 cm2
O118/140 140 mm 64 cm2 4.3 cm2 3.2 cm2 2.6 cm2

The figures are arithmetic from the published base sizes, the same method as in the guide on container size for blueberry and strawberry. To check a vessel you use now, measure its inside floor and divide by your shoot count. If the result is close to 3.2 cm2, the OV80 matches what you do today. The two sets are compared in O118/80 or OV80.

Rooting: do raspberry shoots need a larger vessel?

Check height before floor: whether raspberry rooting needs a larger vessel is not published, so it is a measurement in your own lab. If your rooting shoots stand taller than your multiplication clusters, the floor per shoot can stay the same while the vessel gets taller. The Eco2Box O118/120 and O118/140 give 120 and 140 mm on a 64 cm2 floor.

The O118/50, O118/80, O118/120 and O118/140 all take a 118 mm cover, so multiplication and rooting can run in one cover size. Whether your shoots need 80, 120 or 140 mm is a measurement: take the tallest rooted shoots in your current vessel on the last day and add the medium depth. We have no rooting trial on raspberry or blackberry to point to.

Which filter grade for raspberry multiplication and rooting?

Start multiplication on XXL, the standard grade for most propagation in the Eco2Box filter guide, and run XXL+ beside it. The filter guide suggests XXL+ for fast growers, acclimatisation and hardening off, and gives no separate suggestion for rooting.

The step between the two grades is large. In the oval set, Kv (gas replacements of the air space per day) is 10.83 for XXL and 62.87 for XXL+. More ventilation means less condensation and a higher risk of the medium drying out, so judge the medium on the last day as well as the shoots. Published work says gas exchange should be matched to species, stage and medium, not maximised. The OV80 exists in all four grades and the O118/140 in L, XL and XXL+. The reasoning per stage is in which filter grade to use at which stage.

What does published research say about raspberry in vitro?

Published raspberry work covers media and rooting, and no study was found that compares vessels or filter grades for raspberry or blackberry. Two open-access sources are useful for a vessel decision, with that limit.

  • Lebedev et al. 2018 compared seven raspberry cultivars. Shoots rooted in vitro survived the move to non-sterile conditions at 81 to 98%, against 43 to 76% for shoots that were not rooted. In one cultivar, lowering agar from 8 to 6.5 g/L raised the multiplication rate and caused shoot hyperhydricity (glassy, watery shoots).
  • A review of hyperhydricity by Barua, Igamberdiev and Debnath 2025 (Plants 14(24):3721, doi 10.3390/plants14243721) lists vessel ventilation and gas exchange among its factors, next to gelling agents, growth regulators, light and osmotic conditions.

The raspberry study did not vary the vessel. Since the review lists both gelling agents and vessel ventilation as factors in hyperhydricity, change one of them at a time.

How do you test two vessels on your own clones?

Run two sizes and two grades side by side on one clone, with the same medium, the same shelf and the same shoot count, for at least one full cycle. Four vessel types are enough: OV80 and O118/80, each in XXL and XXL+.

  1. Take explants from one batch and divide them over the four types and your current vessel.
  2. Keep 20 shoots per vessel everywhere, or record the floor per shoot.
  3. Score on the last day: shoots per explant, glassy shoots, condensation, medium left.
  4. Carry the test through rooting and score survival after transfer (acclimatisation, or acclimation in US usage).
  5. Repeat on blackberry separately. Results on one Rubus crop do not transfer by default.

Which mistakes are common with berry cultures?

The first mistake to avoid is changing the vessel, the grade and the shoot count in one step. Three more:

  • Choosing a larger volume for rooting when the shoots need height. Check the height first.
  • Reading a wetter or drier vessel after one week. Judge at the end of the cycle and after transfer.
  • Softening the gel and raising ventilation together. Both are listed as hyperhydricity factors, and you will not know which one worked.

Frequently asked questions

Which pot for 20 raspberry plants per vessel in multiplication?

Compare the Eco2Box OV80 and the O118/80. At 20 shoots the OV80 gives 3.2 cm2 of floor per shoot and the O118/80 gives 4.0 cm2. Both are 80 mm high. Which one fits depends on the width of your clusters at the end of the cycle.

Do I need a bigger pot for raspberry rooting?

That is not published for raspberry, so measure your tallest rooted shoots first. If they outgrow 80 mm, the Eco2Box O118/120 and O118/140 offer 120 and 140 mm of height on a 64 cm2 floor and take the same 118 mm cover as the O118/80.

Which filter grade for raspberry multiplication, XXL or XXL+?

Test both. XXL is the standard grade for most propagation in the Eco2Box filter guide, and XXL+ gives far more gas exchange: Kv 62.87 against 10.83 per day in the oval set. Watch the medium for drying on XXL+.

Is there a vessel study on raspberry or blackberry?

None was found in open literature on 20 November 2026. Published raspberry work covers growth regulators, gelling agents and rooting. Eco2Box has no crop trial on raspberry or blackberry either, which is why this page gives a method and a test plan.

Can blackberry use the same vessel as raspberry?

The method is the same: floor per shoot for multiplication and height for rooting. Whether the same Eco2Box article and grade suit both crops is something only a side-by-side test on each crop can show.

Test two sizes and two grades on your own clones

Tell us the crop, the stage, the shoots per vessel and the vessel you use now, and we propose which Eco2Box articles and grades to compare. A sample set is available on request through the sample page.

For a question about sizes or grades, use the contact page, or browse the product range.

Related guides: Plants per vessel: how many shoots fit in one container, How to choose a tissue culture container: size and floor.

Sources: Eco2Box product specifications and filter guide, checked on 20 November 2026; Lebedev et al. 2018, Plants 8(1):3, doi 10.3390/plants8010003; Barua, Igamberdiev and Debnath 2025, Plants 14(24):3721, doi 10.3390/plants14243721. Floor per shoot is arithmetic from published base sizes. No Eco2Box crop trial on raspberry or blackberry exists.