Skip to content
+32 (0) 9 340 44 04 info@eco2box.com

TL;DR Choose a tissue culture container from four numbers in your own protocol: shoots per vessel, floor area per shoot, shoot height at the end of the cycle and the free height of your shelf. Multiply the first two to get the floor you need, then take the lowest vessel that still leaves headspace. Volume alone misleads: the Eco2Box O95/114 and OV80 hold almost the same volume, yet the O95/114 has 31% less floor.

A tissue culture container is usually listed by its volume in millilitres, and volume is the one number you cannot count shoots against. This guide starts from what your protocol already fixes and ends at an article you can test. It rests on the published Eco2Box specifications and two published studies, and contains no crop trial of our own.

What is the short answer on tissue culture container size?

The floor of the vessel decides how many shoots fit, the height decides how long they can grow, and the filter grade decides the gas exchange. Work through four steps in that order:

  1. Floor needed: shoots per vessel multiplied by floor area per shoot.
  2. Height needed: medium depth, plus shoot height at the end of the cycle, plus headspace.
  3. Shelf check: vessel height plus the room you need to lift it out, and the footprint of the cover.
  4. Filter grade: chosen for the stage, from the grades that exist for that article.

One number usually limits the choice, and which one depends on the stage. The table shows where to start; run the other steps as a check.

Situation Number that decides What to compare
Many short shoots per vessel (multiplication) Floor area Base area per shoot, step 1
Tall shoots or a long cycle (elongation, rooting) Height Vessel height against shoot height, step 2
A full growth room Shelf footprint Sets per shelf multiplied by shoots per set, step 3
Wet shoots or a medium that dries out Filter grade One grade up or down in the same size, step 4

Step 1: how much floor area do the shoots need?

Multiply the number of shoots your protocol puts in one vessel by the floor area it allows per shoot, and pick an article whose base area covers the result. As arithmetic only: 20 shoots at 3 cm2 each need 60 cm2, which the OV80 (64 cm2) and the O118/80 (79 cm2) both cover.

Base area is calculated from the published base size: a circle for the round sets and an ellipse for the oval OV80. The round vessels are narrower at the base than at the cover, so the base is the safe number to plan with. The O118/80 holds 565 ml on 79 cm2, the OV80 holds 540 ml on 64 cm2: 23% more floor in the round set. The same method, with per-shoot figures for ten shoots, is in the guide on container size for blueberry and strawberry.

Step 2: how much height do the shoots need?

Add three heights: the depth of the medium, the height of the shoots on the last day of the cycle and the headspace you want above them. The round Eco2Box sets step through 40, 50, 60, 80, 114, 120 and 140 mm, and the oval OV80 is 80 mm high.

Medium depth follows from the volume you pour. As arithmetic only: 50 ml of medium on a 79 cm2 base stands about 6 mm deep, and a little less in practice because the vessel widens upward. The O118/50, O118/80, O118/120 and O118/140 all take a 118 mm cover, so you can move to a taller vessel and keep the same cover size. How much headspace a crop needs is not published for any vessel we know of. Take it from your own cultures: measure the tallest shoots on the last day of the cycle, in the vessel you use now.

Step 3: does the container fit your shelf?

Check two things on the shelf: the free height between two shelves and the footprint of the cover. A vessel needs its own height plus the room to lift it out. The cover is the widest published dimension of a set: 118 mm or 95 mm for the round sets and 150 x 90 mm for the oval OV80.

As arithmetic only, with covers touching and no gap left for air: a shelf of 1200 x 500 mm takes 40 sets with a 118 mm cover (10 x 4), 60 sets with a 95 mm cover (12 x 5) and 40 OV80 sets (8 x 5). Count again on your own shelf with sample sets, because lamp position and the gap you leave for airflow change the result. This guide makes no claim about stacking: ask us per article.

Step 4: which filter grade goes with the container size?

The filter grade is part of the Eco2Box article, so size and grade are chosen together. There are four grades with rising gas exchange: L (white), XL (yellow), XXL (red) and XXL+ (green). Not every grade exists for every size.

Gas exchange is published as Kv, the number of gas replacements of the air space per day. It runs from 9.87 (L) to 81.35 (XXL+) in the round sets and from 7.44 to 62.87 in the oval set. No Kv is published for the rectangular TP range. The OV80 and the O95/60 come in all four grades, the O118/140 in L, XL and XXL+, and the TP2500 in L only. Published work says gas exchange should be matched to species, stage and medium, not maximised: more ventilation means less condensation and a higher risk of the medium drying out. The starting grade per stage is in which filter grade to use at which stage.

Which Eco2Box container has which volume, height and floor area?

The Eco2Box sets with published sizes run from 210 ml to 2500 ml. Every figure in the table is the published specification, and base area is calculated from the base size. For the rectangular TP sets the base sizes are not confirmed, so no floor area is given for them.

Article Cover Volume Height Base Base area (calculated)
O95/40 95 mm round 210 ml 40 mm 80 mm round 50 cm2
O95/60 95 mm round 280 ml 60 mm 80 mm round 50 cm2
O118/50 118 mm round 300 ml 50 mm 95 mm round 71 cm2
O95/114 95 mm round 520 ml 114 mm 75 mm round 44 cm2
OV80 150 x 90 mm oval 540 ml 80 mm 125 x 65 mm oval 64 cm2
O118/80 118 mm round 565 ml 80 mm 100 mm round 79 cm2
O118/120 118 mm round 870 ml 120 mm 90 mm round 64 cm2
O118/140 118 mm round 1000 ml 140 mm 90 mm round 64 cm2
TP1200 rectangular 1200 ml 73 mm not confirmed not calculated
TP1600 rectangular 1600 ml not confirmed not confirmed not calculated
TP2500 rectangular 2500 ml 89 mm not confirmed not calculated

The O118/80, the TP1600 and the OV80 are the Eco2Box bestsellers. All articles are in the product range, and the two most compared sets are side by side in O118/80 or OV80.

What do published studies say about vessel size?

Two published studies found more growth in larger vessels, and neither gives a rule that transfers to another crop. Both used other vessels than Eco2Box, so they say something about size and nothing about our product.

  • Malik et al. 2022 grew protocorm-like bodies of one Dendrobium orchid hybrid for 11 weeks in plastic vessels of 120 to 470 ml. The growth index rose from 1.367 in the 120 ml vessel to 7.36 in the 470 ml vessel. A 280 ml glass vessel scored 7.123, so volume was not the only factor.
  • McClelland and Smith 1990 compared 60 ml glass tubes, 200 ml glass jars and 350 ml polypropylene vessels on five woody species. Visual density per explant, measured by image analysis, was higher in the larger vessel types, and in vitro rooting was significantly better in larger vessels. Closure effects differed per species.

Which mistakes are common when choosing a container?

The first mistake to avoid is choosing by volume, and the second is changing two things at once. The full list:

  • Choosing by volume. Volume says how much air and medium fit, not how many shoots stand on the floor.
  • Changing vessel and plant number together. Keep shoots per vessel equal, or record floor area per shoot, so you know what made the difference.
  • Taking the highest gas exchange by default. Match the grade to the stage and step one grade at a time.
  • Judging before the cycle ends. Compare on the last day of the cycle, and again after the plants have left the vessel.

Frequently asked questions

Which container size do I need for 20 plants per vessel?

Multiply 20 by the floor area your protocol allows per shoot. At 3 cm2 per shoot you need 60 cm2, which the Eco2Box OV80 (64 cm2) and O118/80 (79 cm2) cover. At 4 cm2 per shoot you need 80 cm2, more than any base area in the table, so ask us about a rectangular TP set or divide the shoots over two vessels.

Is a bigger tissue culture container always the right choice?

No. Two studies found more growth in larger vessels, on one orchid hybrid and on five woody species. A larger vessel also takes more shelf space. Eco2Box advises sizing the vessel on your own shoot count and shoot height, and to compare two sizes side by side.

What is the largest Eco2Box container on this page?

The TP2500 holds 2500 ml and is 89 mm high. It comes in filter grade L only. Among the round Eco2Box sets, the O118/140 is the largest at 1000 ml and 140 mm high, in grades L, XL and XXL+.

Can I keep the same cover size when I change vessel height?

Yes, within a family. Four Eco2Box heights (50, 80, 120 and 140 mm) take a 118 mm cover, and three heights (40, 60 and 114 mm) take a 95 mm cover. Vessel and filter cover are sold together as one set article.

Do I choose the filter grade separately from the container size?

No. In the Eco2Box range the vessel and its filter cover are one set article, and the filter grade is part of that article. Choose the size first, then check which of the four grades exist for it.

Compare two container sizes on your own plants

Send us the crop, the stage, the shoots per vessel and the volume of medium you pour, and we propose two Eco2Box articles to run side by side on a subset of your own lines. A sample set is available on request through the sample page.

For a question about sizes or grades, use the contact page.

Related guides: Plants per vessel: how many shoots fit in one container, New tissue culture lab: choosing one vessel standard.

Sources: Eco2Box product specifications and filter guide (volumes, heights, cover and base sizes, grades per article, Kv values), checked on 20 November 2026; Malik et al. 2022, BioTechnologia 103(1); McClelland and Smith 1990, HortScience 25(7). Base areas, medium depth and shelf counts are arithmetic from those specifications, not measurements.